Miller Electric MILLERMATIC 30E CONTROL/FEEDER Instrukcja Obsługi

TECHNICAL GUIDEFor Air-Cooled MIG Guns - 350, 450 and 550 amp SAFETY AND WARRANTY INFORMATIONINSTALLATIONMAINTENANCE GUIDETECHNICAL DATAOPTIONSEX

Remove from vise and unthread gooseneck by hand.Remove switch from leads and slide handle back. STEP 2Remove power pin from power pin block using a 5/

9.Slide outer jacket forward to expose the copper wiring and leads.10.Pull out the lead wires.11.From the 8” cut, measure 3 ½” towards the front of th

Required PartsUnicable Clamp Kit PART # DESCRIPTION350 AMP 450 AMP 550 AMP 313-8 413-7 513-7 UNICABLE CLAMP KIT (COMPLETE)INDIVIDUAL PARTS308 408 408

4.2 Gun Amperage Ratings GUN MODEL60% DUTY CYCLE - MIXED GASESOR 100% DUTY CYCLE - CO2350 amp 350 amp450 amp 450 amp550 amp 550 ampNOTE: Ratings are

5 Options and Accessories5.1 Specialty and Optional Items - 350, 450, 550 amp Semi-AutoAir-Cooled ITEM PART # DESCRIPTION1 401-10-87 SPOT NOZZLE (BRAS

POWER PIN214-2 LINCOLN POWER PIN LINCOLN LN7, 8 & 9, LN25 SUITCASE, LN22,NA2414-21 ESAB (Non Euro) A-10214-13 PANASONIC 5.3 Feeder Adaptors To b

PART # DESCRIPTION 411-20 SWITCH HOUSING WITH EXTENDEDLEVER411-4 SWITCH HOUSING WITH LOCK ONTRIGGER421 HEAT SHIELD421-1 SHIELD MOUNTING SCREW (NOTSHO

6 Exploded View & Parts List6.1 Exploded View and Parts List - Front End - M001 DESCRIPTION PART # 350 amp 450 amp 550 amp1 NOZZLE2 TOUGH

6.2 Exploded View and Parts List - Back End - M001 DESCRIPTION PART # 350 amp 450 amp 550 amp22 POWER PIN BLOCK 414-400 414-400 414-40023 POW

7 Ordering Information7.1 Gun Standards Chart - M001GUN MODEL GOOSENECK NOZZLE RETAININGHEADGOOSENECKINSULATORCONTACT TIPS350 amp 305-60 401-6-62 404-

Table Of ContentsTOUGH GUN 350, 450, 550 amp Air-Cooled MIG Guns ... 11 Safety and Warranty ...

1 Safety and Warranty1.1 General Safety Guidelines for Semi-Automatic WeldingBefore installation or operation of Tregaskiss Semi-Automatic MIG Guns, p

and Robotic ArmsLow-Stress Robotic Unicables (LSR Unicables) 2 yearsTregaskiss reserves the right to repair, replace or refund the purchase price of n

Insert power pin to shoulder of feeder.Tighten thumbscrew (on Quick Connect Block)securely.Connect control plug lead to control housing ongun.Insert c

plug to control housing of gun and then to feeder.Feed welding wire into power pin by hand andtighten drive rolls.WATER-COOLED GUNS ONLY - Securely cl

STEP 1NOTE: Ensure power supply and water (if applicable) is off and gun is removed from feeder beforeproceeding.Remove nozzle, tip and gas diffuser.

the contact tip afterwards.Remove consumables (nozzle, contact tip and retaininghead).Remove existing QUICK LOAD Liner from the gun.Remove protective

Place gooseneck in vise.Remove both switch housing mounting screws.Slide handle back exposing the cable connection.Loosen the cable / gooseneck connec